Cell body material: high borosilicate glass

The electrolytic cell is an absolutely sealed electrolytic cell system, which is often used in a three-electrode system.

The volume of electrolytic cell ranges from 10ml to 500ml, and can also be customized according to requirements.

The electrode part of electrolytic cell realizes the internal insertion and extraction of electrode through earphone jack on lid, so that the three-electrode system is absolutely sealed.

The electrode of electrolytic cell must be matched with cell body.

The electrolytic cell can not add sand core salt bridge or Lujin capillary and can only use silver-silver chloride electrode.

The electrolytic cell realizes atmosphere protection by adding valves and aeration devices, and the valve connected to aeration device is direction of air intake.

The electrolytic cell is an absolutely sealed system that can be evacuated (less than -100kpa) or pressurized by a valve.

The bottom of electrolytic cell must be made into a round bottom shape for pressurization.

At the same time, for safety reasons, the pressure should not be greater than 0.6MPa

Due to process limitations, the inner wall glass of double-layer electrolytic cell is relatively weak, so pressurization is prohibited.

The electrolytic cell is divided into two types of single layer and double layer,

The double layer adds a constant temperature water bath function on basis of a single layer.

By continuously circulating circulating constant temperature water in jacket layer of electrolytic cell, the measured solution in electrolytic cell achieves a constant temperature effect.

Electrolysis cell cover material:  PTFE, the size of cover is different according to volume of electrolytic cell, size of inner screw cover is basically divided into 50mm, 60mm, 70mm